SECTION 8 - Graflex Super Graphic & Super Speed Graphic Cameras Service Instructions & Parts Catalog - Free Download

Product Description

Graflex Super Graphic & Super Speed Graphic Cameras

INTRODUCTION

This section on the Service Parts Manual covers the Service Instructions and Parts List for the Super Graphic and Super Speed Graphic Cameras. The text and illustrations are based on the Super Graphic Camera. The differences between the Super Graphic and the Super Speed Graphic are clearly described in the Parts List.

A. CAMERA COMPLETE

The Super Graphic Camera (Figure 1 above) includes a camera basic, standard shutter (with lens) mounted in a Super Graphic Lensboard Assembly, matching lens cam and a set of infinity stops to match the focal length of the lens.

The Super Speed Graphic Camera is identical to the Super Graphic except, the Super Speed Graphic is equipped with a 1000 Shutter. The 1000 Shutter does not require a lensboard for mounting.

NOTE: The lens cam is selected after the lens has been optically measured for actual focal length (lens travel).

B. OPTICAL MEASUREMENT OF LENS TRAVEL

Optical measurements are best determined through the use of a collimator with an accurate measuring device. Lens is set up and focused on theoretical infinity and the measuring device set for 0. Lens movement is measured (to nearest . 001 of an inch) from infinity to the following near distance:

At least three different readings should be taken and recorded to insure that a satisfactory figure has been obtained. If equipment is not available, send lens and shutter to nearest Service Department for collimation and selection of cm. (continued)